Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection.

Turn this knob to select TUNETurn this knob to select: Turn this knob to select radio stations.

: Press the right or the left arrow SEEK to: Press the right or the left arrow to go to the next or to the previous station and stay there.

The radio only seeks stations with a strong signal that are in the selected band.

: Press and hold either arrow for SCAN more than two seconds. SCAN displays and the: Press and hold either arrow for more than two seconds. SCAN displays and the radio produces one beep. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again or one of the pushbuttons to stop scanning presets.

To scan preset stations, press and hold either arrow for more than four seconds. PSCN displays and the radio produces two beeps. The radio goes to a preset station, plays for a few seconds, then goes to the next preset station. Press either arrow again or one of the pushbuttons to stop scanning presets.

The radio only scans stations with a strong signal that are in the selected band.

    See also:

    Charging System Light
    The charging system light comes on briefly when the ignition is turned on, but the engine is not running, as a check to show the light is working. The light turns off when the engine is started. If ...

    License Plate Lamp
    To replace one of these bulbs: Passenger Side Shown, Driver Side Similar 1. Push the release tab (A) toward the lamp assembly. 2. Pull the lamp assembly down to remove. A. Bulb Socket B. B ...

    Exterior Lighting
    The exterior lamp control is located on the instrument panel on the outboard side of the steering wheel. : Turns off the exterior lamps. The knob returns to the AUTO position after it is released ...