Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection.

TUNE: Turn this knob to select radio stations.

: Press either the SEEK or the SEEK TYPE: Press either the SEEK or the TYPE arrows to go to the next or to the previous station and stay there.

The radio only seeks stations with a strong signal that are in the selected band.

: Press and hold either the SCAN SCAN or: Press and hold either the SCAN or the TYPE arrows for two seconds until SCAN displays and a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either the SCAN or the TYPE arrows again to stop scanning.

To scan preset stations, press and hold either the SCAN or the TYPE arrows for more than four seconds. PSCN displays and a double beep sounds. The radio goes to a preset station, plays for a few seconds, then goes to the next preset station. Press either the SCAN or the TYPE arrows again to stop scanning presets.

The radio only scans stations with a strong signal that are in the selected band.

    See also:

    Air Quality Sensor
    This will allow you to select whether the system will operate at high or low sensitivity. Only vehicles with the dual zone climate control will have this option. Press SELECT when Air Quality ...

    Auto Fan Speed
    This will allow you to select the automatic fan speed. It can be adjusted to run lower or higher than normal. Press SELECT when Auto Fan Speed is highlighted to open the menu. Turn the Menu ...

    Tire Pressure
    Tires need the correct amount of air pressure to operate effectively. Notice: Neither tire underinflation nor overinflation is good. Underinflated tires, or tires that do not have enough air, can r ...