Turn and Lane-Change Signals
An arrow on the instrument panel cluster will flash in the direction of the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change. The turn signal flashes three times.
The lever returns to its starting position when it is released.
If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb may be burned out. Have the bulbs replaced. If the bulb is not burned out, check the fuse. See Fuses and Circuit Breakers for more information.
See also:
Care of Safety Belts
Keep belts clean and dry.
WARNING:
Do not bleach or dye safety belts. It may severely
weaken them. In a crash, they might not be able
to provide adequate protection. Clean safety belts
only wi ...
Sunroof
For vehicles with a sunroof, the sunroof only operates when the ignition is in
ON/RUN or ACC/ ACCESSORY, or in Retained Accessory Power (RAP). See Retained Accessory
Power (RAP) for more i ...
Brake Fluid
The brake master cylinder and, on manual transmission vehicles, the clutch hydraulic system use the same reservoir. See Engine Compartment Overview for the location of the reservoir. The reser ...