Head Restraint Removal and Reinstallation
The rear outboard head restraints can be removed if they interfere with the proper installation of the child restraint.
To remove the head restraint:
1. Partially fold the seatback forward. See Rear Seats for additional information.
2. Press both buttons on the head restraint posts at the same time, and pull up on the head restraint.
3. Store the head restraint in the trunk of the vehicle.
4. When the child restraint is removed, reinstall the head restraint before the seating position is used.
WARNING
With head restraints that are not installed and adjusted properly, there is a greater chance that occupants will suffer a neck/ spinal injury in a crash. Do not drive until the head restraints for all occupants are installed and adjusted properly.
To reinstall the head restraint:
1. Insert the head restraint posts into the holes in the top of the seatback. The notches (A) on the posts must face the driver side of the vehicle.
2. Push the head restraint down. If necessary, press the height adjustment release button to further lower the head restraint. See Head Restraints .
3. Try to move the head restraint to make sure that it is locked in place.
See also:
Service
Never try to do your own service on
eAssist components. You can be
injured and the vehicle can be
damaged if you try to do your own
service work. Service and repair of
these high voltage com ...
Power Door Locks
Select Power Door Locks and the
following will be displayed:
• Unlocked Door Anti Lock Out
• Delayed Door Lock
• Auto Door Unlock ...
What to Add
Use only new DOT 3 brake fluid from a sealed container.
See Recommended Fluids and Lubricants.
Always clean the brake fluid reservoir cap and the
area around the cap before removing it. This helps ...