Using Voice Commands During a Planned Route
Cancel Route
1. Push 
. System responds:
“OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?”.
2. Say “Yes.” System responds:
“OK, route canceled.”.
3. Say “Goodbye.” Exits voice commands.
Route Preview
1. Push . System responds:
“OnStar ready,” then a tone.
2. Say “Route Preview.” System responds with the next three maneuvers.
3. Say “Goodbye.” Exits voice commands.
Repeat
1. Push . System responds:
“OnStar ready,” then a tone.
2. Say “Repeat.” System responds with the last direction given, then responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
Get My Destination
1. Push . System responds:
“OnStar ready,” then a tone.
2. Say “Get my destination.”.
System responds with miles to the destination, then responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
See also:
Taillamps and Back-Up Lamps
A. Taillamp
B. Back-up Lamp
To replace an auxiliary taillamp or back-up lamp bulb:
1. Open the trunk. See Trunk.
2. Remove the three fasteners from the trunk trim.
3. Pull back the trunk trim ...
DSP (Digital Signal Processing)
Settings
For vehicles with DSP, it is used to
provide a choice of different
listening experiences.
The DSP settings for the radio with
CD are:
• normal - Select this setting to
adjust the audio for ...
Control of a Vehicle
Braking, steering, and accelerating are important factors in helping to control
a vehicle while driving. ...