Flash-to-Pass

To flash the high beams, pull the turn signal/lane change lever toward you, and release.

    See also:

    Jump Starting (On-board with eAssist Only)
    If the vehicle fails to crank, it may be jump started by using the eAssist battery to charge the 12-volt battery. Use the following procedure to activate the on-board jump start using the DIC ...

    Overheated Engine Protection Operating Mode
    This emergency operating mode allows the vehicle to be driven to a safe place in an emergency situation. If an overheated engine condition exists, an overheat protection mode which alternate ...

    Muting a Call
    During a call, all sounds from inside the vehicle can be muted so that the person on the other end of the call cannot hear them. To Mute a call 1. Press . The system responds with “Ready” ...