Conditions in Which Remote Start Will Not Work
The remote start will not operate if:
• The key is in the ignition (key access) or the ignition is in any position other than OFF (keyless access).
• The transmitter is in the vehicle (keyless access).
• The hood is not closed.
• The hazard warning flashers are on.
• There is an emission control system malfunction.
• The engine coolant temperature is too high.
• The oil pressure is low.
• Two remote vehicle starts have already been used.
• The vehicle is not in P (Park).
See also:
Rear Seats
Either side of the rear seatback can be folded.
Notice: Folding a rear seat with the safety belts still fastened may cause damage
to the seat or the safety belts. Always unbuckle the safety belts a ...
Washer Fluid
What to Use
When windshield washer fluid is needed, be sure to read the manufacturer's instructions before use. If operating the vehicle in an area where the temperature may fall below freezing, use ...
Checking Coolant
The vehicle must be on a level surface when checking
the coolant level.
The coolant level should be at or above the FULL
COLD mark when the engine is cold. The coolant level
should be above the ...