What to Use

Adding only plain water or some other liquid to the cooling system can be dangerous. Plain water and other liquids, can boil before the proper coolant mixture will. WARNING
Adding only plain water or some other liquid to the cooling system can be dangerous. Plain water and other liquids, can boil before the proper coolant mixture will.

The coolant warning system is set for the proper coolant mixture.

With plain water or the wrong mixture, the engine could get too hot but you would not get the overheat warning. The engine could catch fire and you or others could be burned. Use a 50/50 mixture of clean, drinkable water and DEX-COOL coolant.

Use a 50/50 mixture of clean, drinkable water and DEX-COOL coolant. If using this mixture, nothing else needs to be added.

This mixture:

► Gives freezing protection down to −37°C (−34°F), outside temperature.

► Gives boiling protection up to 129°C (265°F), engine temperature.

► Protects against rust and corrosion.

► Will not damage aluminum parts.

► Helps keep the proper engine temperature.

Notice: If an improper coolant mixture is used, the engine could overheat and be badly damaged.

The repair cost would not be covered by the vehicle warranty.

Too much water in the mixture can freeze and crack the engine, radiator, heater core, and other parts.

Never dispose of engine coolant by putting it in the trash, pouring it on the ground, or into sewers, streams, or bodies of water. Have the coolant changed by an authorized service center, familiar with legal requirements regarding used coolant disposal. This will help protect the environment and your health.

    See also:

    Fog Lamps
    To replace the fog lamp bulb: 1. Locate the bulb assembly under the front fascia. 2. Disconnect the electrical connector from the bulb assembly. 3. Remove the bulb by turning it counterclockwise an ...

    Rear Vision Camera Error Messages
    SERVICE REAR VISION CAMERA SYSTEM: This message can display when the system is not receiving information it requires from other vehicle systems. If any other problem occurs or if a problem ...

    Using ABS
    Do not pump the brakes. Just hold the brake pedal down firmly and let ABS work. You might hear the ABS pump or motor operating and feel the brake pedal pulsate, but this is normal. ...