License Plate Lamp
To replace one of these bulbs:
1. Remove the license plate.
2. Reach up through the opening above the license plate to access the two license plate lamps.
3. Turn the socket counterclockwise to remove.
4. Grasp the bulb in the socket and pull straight out.
5. Push the bulb straight into the socket until it clicks to secure it.
6. Push the socket in and turn it clockwise to secure it.
7. Reinstall the license plate in its original location.
See also:
Sum greater than pieces
This LaCrosse just glided through the hills and country roads around Milford
— home to GM's proving grounds — where I test drove it.
There were a few times, if you really stepped on the gas, t ...
Radio Data System (RDS)
The audio system has a Radio Data
System (RDS). RDS features are available
for use only on FM stations that broadcast
RDS information.
With RDS, the radio can do the following:
• Seek to st ...
Sensing System for Passenger
Airbag
The passenger sensing system will turn off the right
front passenger frontal airbag and seat-mounted
side impact airbag under certain conditions. The driver
airbags and roof-rail airbags are not ...