Resuming a Set Speed
If cruise control is set at a desired speed and the brakes are applied, this shuts off the cruise control.
However, it does not need to be reset.
Once your vehicle reaches a speed of about 40 km/h (25 mph) or more, press the +RES button on the steering wheel. The vehicle goes back to the previously selected speed and stays there.
See also:
Stoplamp,Taillamp, and Turn Signal Lamp
Driver Side Shown, Passenger Side Similar
A. Taillamp
B. Turn Signal Lamp
C. Stoplamp/Taillamp
To replace any one of these bulbs:
1. Open the trunk.
2. Remove the push pins securing the trunk ...
Canceling a Remote Start
To cancel a remote start, do one of the following:
. Aim the RKE transmitter at the vehicle and press and hold
until the parking lamps turn off.
. Turn on the hazard warning flashers.
. Turn t ...
Head Restraint Adjustment
Do not drive until the head restraints
for all occupants are installed and
adjusted properly.
To achieve a comfortable seating
position, change the seatback
recline angle as little as necessa ...