Ultrasonic Rear Parking Assist (URPA)
For vehicles with the URPA system, it operates at speeds less than 8 km/h (5 mph), and assists the driver with parking and avoiding objects while in R (Reverse).
The sensors on the rear bumper are used to detect the distance to an object up to 2.5 m (8 ft) behind the vehicle, and at least 25 cm (10 in) off the ground.
WARNING:
The Ultrasonic Rear Parking Assist (URPA)
system does not replace driver vision. It cannot
detect:
• objects that are below the bumper,
underneath the vehicle, or if they are too
close or far from the vehicle
• children, pedestrians, bicyclists, or pets.
If you do not use proper care before and while
backing; vehicle damage, injury, or death could
occur. Even with URPA, always check behind the
vehicle before backing up. While backing, be sure
to look for objects and check the vehicle’s mirrors.
The display is located on the rear shelf, below the rear window, and can be seen by looking over your right shoulder.
URPA uses three color-coded lights to provide distance and system information.
See also:
Exit Lighting
This allows selection of how long
the exterior lamps stay on when
leaving the vehicle and it is dark
outside.
Press SELECT when Exit Lighting is
highlighted. Turn the Menu knob to
select Of ...
Front Fog Lamps
For vehicles with front fog lamps, the button is located on the outboard side
of the instrument panel.
The ignition must be on to turn on the fog lamps.
(Front Fog Lamps): Press to turn
the f ...
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle
will work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement tr ...