Parking/Turn Signal Lamp
1. Open the hood. See Hood .
2. Remove the parking/turn signal lamp bulb socket from the headlamp assembly by turning counterclockwise.
3. Remove the bulb from the bulb socket by pulling it straight out.
4. Install the new bulb in the bulb socket.
5. Install the bulb socket into the headlamp assembly by turning clockwise.
See also:
Introduction
Notice: Maintenance intervals, checks, inspections,
recommended fluids, and lubricants are necessary
to keep this vehicle in good working condition.
Damage caused by failure to follow scheduled
...
Radio Messages
CAL ERR (Calibration Error): The audio system
has been calibrated for your vehicle from the
factory. If CAL ERR displays, it means that the
radio has not been configured properly for
the vehicle a ...
EPB Release
To release the EPB, place the ignition in the ON/RUN position, apply and hold
the brake pedal, and push down momentarily on the EPB switch. If you attempt to
release the EPB without the brake peda ...