Radio Frequency Statement

This vehicle has systems that operate on a radio frequency that comply with Part 15 of the Federal Communications Commission (FCC) rules and with Industry Canada Standards RSS-GEN/210/220/310.

Operation is subject to the following two conditions:

1. The device may not cause harmful interference.

2. The device must accept any interference received, including interference that may cause undesired operation of the device.

Changes or modifications to any of these systems by other than an authorized service facility could void authorization to use this equipment.

    See also:

    Headlamps, Front Turn Signal, andParking Lamps
    To replace a bulb, do the following: 1. Open the hood. 2. Remove the grille by grasping and pulling it forward. 3. Lift the two headlamp retaining clips. 4. Pull the headlamp assembly away from ...

    Floor Mats
    WARNING! If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stop ...

    Finish Damage
    Any stone chips, fractures or deep scratches in the finish should be repaired right away. Bare metal will corrode quickly and may develop into major repair expense. Minor chips and scratches can ...