SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, or 3.5m(11 ft). This zone starts at each side mirror and goes back approximately 5.0 m(16 ft). The height of the zone is approximately between 0.5 m(1.5 ft) and 2.0m(6 ft) off the ground.
The SBZA detection zones do not change if the vehicle is towing a trailer. So be extra careful when changing lanes while towing a trailer.
See also:
Tire Sealant
Read and follow the safe handling
instructions on the label adhered to
the compressor.
Check the tire sealant expiration
date on the sealant canister. The
sealant canister should be replaced ...
Headlamp High/ Low-Beam Changer
Headlamp High/Low-Beam Changer: Push the turn signal/lane change lever away from you and release, to turn the high beams on.
To return to low beams, push the lever again or pull it toward you and ...
Increasing Speed While Using Cruise
Control
To increase the cruise speed while using cruise control:
• Press and hold the +RES button on the steering
wheel until the desired speed is reached, then
release it.
• To increase vehicle spe ...
