Voice Recognition
The voice recognition system uses commands to control the system and dial phone numbers.
Noise: The system may not recognize voice commands if there is too much background noise.
When to Speak: A tone sounds to indicate that the system is ready for a voice command. Wait for the tone and then speak.
How to Speak: Speak clearly in a calm and natural voice.
See also:
Tilt Wheel
The steering wheel should be adjusted before you
drive.
The tilt lever is located
to the left of the steering
column, under the
turn signal lever.
It can be raised to the highest level to give ...
Stoplamp,Taillamp, and Turn Signal Lamp
Driver Side Shown, Passenger Side Similar
A. Taillamp
B. Turn Signal Lamp
C. Stoplamp/Taillamp
To replace any one of these bulbs:
1. Open the trunk.
2. Remove the push pins securing the trunk ...
SBZA Detection Zones
The SBZA sensor covers a zone of
approximately one lane over from
both sides of the vehicle,
or 3.5m(11 ft). This zone starts at
each side mirror and goes back
approximately 5.0 m(16 ft). Th ...
