Jump Start (eAssist Only)
This display allows for on-board jump starting of the vehicle. See “Jump Starting (On-board with eAssist Only)” for more information.
See also:
Using the Directory Command
The directory command lists all of the name tags stored by the system.
To use the directory command:
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” f ...
Using Voice Commands
During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone. Say
“Cancel route.” System
responds: “Would you like to
cancel route directions to your
destination?”.
2. Sa ...
If You Cannot See the HUD Image When the Ignition Is On
• Is anything covering the
HUD lens?
• Is the HUD dimmer setting bright
enough?
• Is the HUD image adjusted to
the proper height?
• Are you wearing polarized
sunglasses?
• Still ...
