Setting the Time and Date (With Date Display)

1. Press the CONFIG button and select Time and Date Settings, or press 2. Select Set Time or Set Date..

2. Select Set Time or Set Date.

3. Turn the Menu knob to adjust the highlighted value.

4. Press SELECT to select the next value.

5. To save the time or date and return to the Time and Date Settings menu, press the press SELECT after adjusting BACK button at any time or press SELECT after adjusting the minutes or year.

    See also:

    Hazard Warning Flashers
    Hazard Warning Flasher: Press this button located on the instrument panel above the audio system, to make the front and rear turn signal lamps flash on and off. Press again to turn the flashe ...

    Checking Coolant
    The vehicle must be on a level surface when checking the coolant level. Check to see if coolant is visible in the coolant surge tank. If the coolant inside the coolant surge tank is boiling, do not d ...

    Extending Engine Run Time
    For a 10-minute extension, repeat Steps 1–3 while the engine is still running. The remote start can be extended once. When the remote start is extended, the second 10 minutes will start immediate ...