Front Turn Signal/Parking/Side Marker Lamps (Base and Up-Level)
To replace the front turn signal, parking lamp, or sidemarker lamp:
1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.
2. Remove the bulb socket from the headlamp assembly by turning it counterclockwise.
3. Remove the bulb from the socket.
4. Replace the bulb in the bulb socket.
5. Install the bulb socket in the headlamp assembly by turning it clockwise.
6. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer.
See also:
Tire Messages
TIRE PRESSURE LOW ADD AIR TO TIRE
On vehicles with the Tire Pressure Monitor System (TPMS), this message displays
when the pressure in one or more of the vehicle's tires is low.
The low tire p ...
Leaving After Parking on a Hill
1. Apply and hold the brake pedal while you:
• start the engine,
• shift into a gear, and
• release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is cle ...
Ignition Positions (Keyless Access)
The vehicle has an electronic keyless ignition with pushbutton start.
Pressing the button cycles it through three modes: ACC/ACCESSORY, ON/RUN/START,
and Stopping the Engine/OFF.
The transmitter ...