Using the Directory Command

The directory command lists all of the name tags stored by the system.

To use the directory command:

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.2. Say “Directory.” The system responds “Directory” and lists all stored name tags. The system returns to the main menu when the list is complete.

    See also:

    Interior Lighting
    Courtesy Lamps When any door is opened, the interior lamps turn on to enter and exit the vehicle. Turn the instrument panel brightness control located on the left side of the steering wheel, ...

    Extending Engine Run Time
    For a 10-minute extension, repeat Steps 1–3 while the engine is still running. The remote start can be extended once. When the remote start is extended, the second 10 minutes will start immediate ...

    Reducing Speed While UsingCruise Control
    Press in the set button at the end of the lever until you reach the desired speed, then release it. Each time you do this, you will go about 1 mph (1.6 km/h) slower. ...