License Plate Lamp
To replace one of these bulbs, do the following:
1. Remove the two screws holding the license plate lamp lens.
2. Pull the lens away from the lamp assembly.
3. Pull the old bulb from the bulb socket, keeping
the bulb straight as you pull it out.
4. Install the new bulb.
5. Replace the lamp assembly lens and tighten
the screws.
See also:
Lower Anchor and Top Tether AnchorLocations
Second Row
(Top Tether Anchor):
Seating positions with
top tether anchors.
(Lower Anchor):
Seating positions with
two lower anchors.
To assist you in locating
the lower anchors, ...
Using Voice Commands
During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone. Say
“Cancel route.” System
responds: “Would you like to
cancel route directions to your
destination?”.
2. Sa ...
Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System
(TPMS). The TPMS is designed to warn the driver
when a low tire pressure condition exists. TPMS sensors
are mounted onto each tire and wheel ...