When You Are Ready to Leave AfterParking on a Hill

1. Apply your regular brakes and hold the pedal down while you:

• start your engine,
• shift into a gear, and
• release the parking brake.

2. Let up on the brake pedal.
3. Drive slowly until the trailer is clear of the chocks.
4. Stop and have someone pick up and store the chocks.

    See also:

    Programming Transmitters to the Vehicle
    Only RKE transmitters programmed to the vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer/retailer. When the replacement tr ...

    Using Voice Commands During a Planned Route
    Cancel Route 1. Push . System responds: “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?”. 2. Sa ...

    Setting Cruise Control
    Cruise control will not work if the parking brake is set, or if the master cylinder brake fluid level is low. The cruise control light on the instrument panel cluster comes on after the cruise co ...