Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection.

: Turn this knob to select radio TUNE stations.: Turn this knob to select radio stations.

: Press either the SEEK or the SEEK TYPE: Press either the SEEK or the TYPE arrows to go to the next or to the previous station and stay there.

The radio only seeks stations with a strong signal that are in the selected band.

: Press and hold either the SCAN SCAN or: Press and hold either the SCAN or the TYPE arrows for two seconds until SCN displays and a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either the SCAN or the TYPE arrows again to stop scanning.

To scan preset stations, press and hold either the SCAN or the TYPE arrows for more than four seconds. PSC displays and a double beep sounds.

The radio goes to a preset station, plays for a few seconds, then goes to the next preset station.

Press either the SCAN or the TYPE arrows again to stop scanning presets.

The radio only scans stations with a strong signal that are in the selected band.

    See also:

    Storing a Station as a Favorite
    Stations from all bands can be stored in any order in the favorite pages. Up to six stations can be stored in each favorite page and the number of available favorite pages can be set. Stor ...

    Center Console Storage Area
    If equipped, squeeze the front lever while lifting the top to open it. Your vehicle’s console will be equipped with cupholders located on the front and rear of the storage compartment. The ...

    Lumbar Adjustment
    Lumbar Adjustment If available, press and hold the front or rear of the control to increase or decrease lumbar support. To raise or lower lumbar support, press and hold the top or bottom of ...