Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection.

Turn this knob to select TUNETurn this knob to select: Turn this knob to select radio stations.

: Press the right or the left arrow SEEK to: Press the right or the left arrow to go to the next or to the previous station and stay there.

The radio only seeks stations with a strong signal that are in the selected band.

: Press and hold either arrow for SCAN more than two seconds. SCAN displays and the: Press and hold either arrow for more than two seconds. SCAN displays and the radio produces one beep. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again or one of the pushbuttons to stop scanning presets.

To scan preset stations, press and hold either arrow for more than four seconds. PSCN displays and the radio produces two beeps. The radio goes to a preset station, plays for a few seconds, then goes to the next preset station. Press either arrow again or one of the pushbuttons to stop scanning presets.

The radio only scans stations with a strong signal that are in the selected band.

    See also:

    Instrument Panel
    A. Exterior Lamp Controls. Fog Lamps (If Equipped). Instrument Panel Illumination Control. Head-Up Display (HUD) (If Equipped). B. Air Vents. C. Turn and Lane-Change Lever. See Turn and La ...

    High-Beam On Light
    This light comes on when the high-beam headlamps are in use. See Headlamp High/Low-Beam Changer for more information. ...

    Engine Coolant Heater
    The engine coolant heater can provide easier starting and better fuel economy during engine warm-up in cold weather conditions at or below 0°F (−18°C). Vehicles with an engine coolant he ...