Voice Pass-Thru
Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature. To access contacts stored in the cell phone:
1. Press 
. The system responds “Ready,”
followed by a tone.
2. Say “Bluetooth.” This command can be skipped.
3. Say “Voice.” The system responds “OK, accessing <phone name>.”
The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.
See also:
When the System Does Not Seem to
Work Properly
If the URPA system will not activate due to a temporary
condition, the message PARK ASSIST OFF will be
displayed on the DIC and a red light will be shown on
the rear URPA display when the shift ...
Headlamp Wiring
An electrical overload may cause the lamps to go on and off, or in some cases
to remain off. Have the headlamp wiring checked right away if the lamps go on and
off or remain off. ...
Uniform Tire Quality Grading
Quality grades can be found where applicable on the tire sidewall between tread
shoulder and maximum section width. For example: ...