Entry Lighting
The headlamps, parking lamps, taillamps, and most of the interior lamps turn
on briefly when 
is pressed on the
Remote Keyless Entry (RKE) transmitter. After about 30 seconds the exterior lamps
turn off, and then the dome and remaining interior lights will dim to off. Entry
lighting can be disabled manually by changing the ignition out of the OFF position,
or by pressing the RKE transmitter 
button.
This feature can be changed. See Vehicle Personalization .
See also:
Headlamps, Front Turn Signal, andParking Lamps
To replace a bulb, do the following:
1. Open the hood.
2. Remove the grille by grasping and pulling it
forward.
3. Lift the two headlamp retaining clips.
4. Pull the headlamp assembly away from ...
When the System Does Not Seem to
Work Properly
If the URPA system will not activate due to a temporary
condition, the message PARK ASSIST OFF will be
displayed on the DIC and a red light will be shown on
the rear URPA display when the shift ...
License Plate Lamp
To replace one of these bulbs:
1. Push the left end of the lamp assembly toward the right.
2. Turn the lamp assembly down to remove it from the fascia.
A. Bulb Socket
B. Bulb
C. Lamp Assembly ...