Voice Pass-Thru

Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature.

To access contacts stored in the cell phone:

1. Press responds “Ready,” followed by. The system responds “Ready,” followed by a tone.

2. Say “Bluetooth.” This command can be skipped.

3. Say “Voice.” The system responds “OK, accessing <phone name>.”.

The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.

    See also:

    DIC Operation and Displays
    The DIC has different displays which can be accessed by using the DIC buttons on the turn signal lever, located on the left side of the steering wheel. The DIC displays trip, fuel, and vehicle sys ...

    Manual Front Seats
    To adjust a manual seat: 1. Pull the handle at the front of the seat. 2. Slide the seat to the desired position and release the handle. 3. Try to move the seat back and forth to be sure it is l ...

    Introduction
    GENERAL MOTORS, GM, the GM Emblem, BUICK, the BUICK Emblem, and the name LUCERNE are registered trademarks of General Motors Corporation. This manual describes features that may or may not be ...