Floor Mats

If a floor mat is the wrong size or is not properly installed, it can interfere with the accelerator pedal and/or brake pedal. WARNING
If a floor mat is the wrong size or is not properly installed, it can interfere with the accelerator pedal and/or brake pedal.

Interference with the pedals can cause unintended acceleration and/or increased stopping distance which can cause a crash and injury. Make sure the floor mat does not interfere with the accelerator or brake pedal.

Use the following guidelines for proper floor mat usage:

► The original equipment floor mats were designed for your vehicle. If the floor mats need replacing, it is recommended that GM certified floor mats be purchased. Non-GM floor mats may not fit properly and may interfere with the accelerator or brake pedal. Always check that the floor mats do not interfere with the pedals.

► Use the floor mat with the correct side up. Do not turn it over.

► Do not place anything on top of the driver side floor mat.

► Use only a single floor mat on the driver side.

► Do not place one floor mat on top of another.

Removing and Replacing the Floor Mats

Pull up on the rear of the floor mat to unlock each retainer and remove.

Reinstall by lining up the floor mat retainer openings over the carpet retainers and snap into position.

Reinstall by lining up the floor mat retainer openings over the carpet retainers and snap into position.

Make sure the floor mat is properly secured in place.

Verify the floor mat does not interfere with the accelerator, clutch, or the brake pedal.

    See also:

    Ignition Positions (Keyless Access)
    Ignition Positions (Keyless Access) The vehicle has an electronic keyless ignition with pushbutton start. Pressing the button cycles it through three modes, ACC/ACCESSORY, ON/RUN/START, an ...

    Certification Label
    Label Example A vehicle-specific Certification label is attached to the driver side center pillar (B-pillar). The label tells the gross weight capacity of the vehicle, called the Gross Vehicle Weig ...

    Outlet Adjustment
    Use the air outlets located in the center and on the sides of your instrument panel to direct the airflow. Operation Tips • Keep the hood and front air inlets free of ice, snow, or any other ob ...