Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

Buick Regal / Buick Regal Owners Manual / Vehicle Care / Bulb Replacement / Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

A. Taillamp/Sidemarker Lamp

A. Taillamp/Sidemarker Lamp
B. Taillamp
C. Stop/Turn Signal Lamp
D. Back-up Lamp

To replace any one of these bulbs:

1. Open the trunk. See Trunk Release .
2. Remove the taillamp assembly access panel.
3. Remove the two nuts that secure the taillamp assembly.
4. Remove the taillamp assembly and detach the wiring harness connector.

A. Back-up Lamp

A. Back-up Lamp
B. Taillamp
C. Stop/Turn Signal Lamp
D. Taillamp/Sidemarker Lamp

5. Turn the bulb socket counterclockwise to remove it.
6. Pull the bulb from the socket.
7. Install a new bulb.
8. Turn the bulb socket clockwise to install it.
9. Reverse Steps 2 through 4 to reinstall the taillamp assembly.

    See also:

    Power Flow Gauge (eAssist Only)
    This display shows the operating mode of the eAssist system and the high voltage battery charge level. The animation indicates the direction of energy flow. ...

    Brake System Warning Light
    When the ignition is on, the brake system warning light will come on when you set your parking brake. The light will stay on if your parking brake does not release fully. If it stays on after your ...

    Engine Identification
    The eighth character in the VIN is the engine code. This code identifies the vehicle’s engine, specifications, and replacement parts. See “Engine Specifications” under Capacities and Speci ...