Park Brake and P (Park) Mechanism Check
WARNING
When you are doing this check, the vehicle could begin to move.
You or others could be injured and property could be damaged.
Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.
► To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only. ► To check the P (Park) mechanism's holding ability: With the engine running, shift to P (Park).Then release the parking brake followed by the regular brake.
Contact your dealer if service is required.
See also:
Dome Lamps
The interior lamps control located in the overhead console controls both the front and rear interior lamps.
To operate:
(Off): Turns the lamps off.
(Door): Turns the lamps on when any ...
Customer Satisfaction Procedure
Your satisfaction and goodwill are important to
your dealer and to Buick. Normally, any concerns with
the sales transaction or the operation of your vehicle will
be resolved by your GM dealer’ ...
Driver Shift Control (DSC)
Notice:
Driving with the engine at
a high rpm without upshifting
while using Driver Shift Control
(DSC), could damage the vehicle.
Always upshift when necessary
while using DSC.
DSC allows ...