Using the Dial Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.

2. Say “Dial.” The system responds “Dial using <phone name>.

Number please,” followed by a tone.

3. Say the entire number without pausing.

► If the system recognizes the number, it responds with “OK, Dialing” and dials the number.

► If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say “Yes.” The system responds “OK, Dialing” and dials the number. If the number is not correct, say “No.” The system will ask for the number again.

    See also:

    Checking the Fluid Level
    Prepare your vehicle as follows: 1. Park your vehicle on a level place. Keep the engine running. 2. With the parking brake applied, place the shift lever in PARK (P). 3. With your foot on the b ...

    Rear Window Sunshade
    On vehicles with a rear window sunshade, the switch is on the console to the right of the shift lever. The sunshade only operates when the ignition is in ON/RUN or ACC/ACCESSORY. To open the s ...

    Rear Compartment Fuse Block
    The rear compartment fuse block, if equipped, is located on the left side of the trunk behind a cover. The vehicle may not be equipped with all of the fuses, relays, and features shown. ...