Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection.

: Turn this knob to select radio TUNE stations.: Turn this knob to select radio stations.

: Press either the SEEK or the SEEK TYPE: Press either the SEEK or the TYPE arrows to go to the next or to the previous station and stay there.

The radio only seeks stations with a strong signal that are in the selected band.

: Press and hold either the SCAN SCAN or: Press and hold either the SCAN or the TYPE arrows for two seconds until SCN displays and a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either the SCAN or the TYPE arrows again to stop scanning.

To scan preset stations, press and hold either the SCAN or the TYPE arrows for more than four seconds. PSC displays and a double beep sounds.

The radio goes to a preset station, plays for a few seconds, then goes to the next preset station.

Press either the SCAN or the TYPE arrows again to stop scanning presets.

The radio only scans stations with a strong signal that are in the selected band.

    See also:

    Playing the Radio
    PWR (Power): Press this knob to turn the system on and off. VOL (Volume): Turn this knob clockwise or counterclockwise to increase or to decrease the volume. INFO (Information): When the ...

    Engine Oil Additives
    Do not add anything to the oil. The recommended oils with the starburst symbol that meet GM Standard GM6094M are all you will need for good performance and engine protection. ...

    Loading Your Vehicle for Off-RoadDriving
    CAUTION: • Cargo on the load floor piled higher than the seatbacks can be thrown forward during a sudden stop. You or your passengers could be injured. Keep cargo below the top of the seat ...