Gate Operator and CanadianProgramming
Canadian radio-frequency laws require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for Universal Home Remote to pick up the signal during programming. Similarly, some U.S. gate operators are manufactured to time out in the same manner.
If you live in Canada, or you are having difficulty programming a gate operator or garage door opener by using the “Programming Universal Home Remote” procedures, regardless of where you live, replace Step 3 under “Programming Universal Home Remote” with the following:
Continue to press and hold the Universal Home Remote button while you press and release every two seconds (cycle) the hand-held transmitter button until the frequency signal has been successfully accepted by the Universal Home Remote. The Universal Home Remote indicator light will flash slowly at first and then rapidly.
Proceed with Step 4 under “Programming Universal Home Remote” to complete.
See also:
Vehicle Identification Number (VIN)
Vehicle Identification Number (VIN)
This legal identifier is in the front corner of the
instrument panel, on the driver side. It can be seen
through the windshield from outside. The VIN also
...
Place a Call Using a Stored
Number
1. Push . System responds:
“OnStar ready.”.
2. Say “Call <name tag>.” System
responds: “OK, calling
<name tag>.” ...
Power Seat Adjustment
Power Seat Adjustment
To adjust a power seat:
• Move the seat forward or
rearward by sliding the control
forward or rearward.
• Raise or lower the front or rear
part of the seat cushion ...