Erasing Universal Home RemoteButtons

You should erase the programmed buttons when you sell the vehicle or terminate your lease.

To erase either rolling code or fixed code on the Universal Home Remote device, do the following:

1. Press and hold the two outside buttons at the same time for approximately 20 seconds, until the indicator lights, located directly above the buttons, begin to blink rapidly.
2. Once the indicator lights begin to blink, release both buttons. The codes from all button will be erased.

For additional information on Universal Home Remote.

    See also:

    Power Seats
    Power Seats To adjust the seat: • Move the seat forward or rearward by moving the horizontal control forward or rearward. • Raise or lower the front or rear part of the seat cushion b ...

    Power Reclining Seatbacks
    Driver’s Seat with Power Seat Control, Power Recline, and Power Lumbar shown If the seats have power reclining seatbacks, the controls used to operate them are located on the outboard side ...

    Remote Vehicle Start
    With this feature the engine can be started from outside of the vehicle. ...