Outside Power Mirror
The outside power mirror control is located on the driver’s door.
1. Turn the knob toward the mirror you desire
to adjust.
2. Move the control in the direction you want the
mirror to go.
3. Adjust the mirror in all four directions so that
you can see the side of your vehicle and the
area behind your vehicle.
4. After adjusting each mirror, turn the control to
the center position so the mirror cannot be
moved.
If you reach the mirror’s end of the travel position in any direction, the mirror will enter a ratcheting mode. This action is harmless. It is a warning that the mirror can go no further. To stop this action, back the mirror up by moving the control in the opposite direction.
Fold the mirror in manually before entering a car wash. To do this, pull the mirror in toward the vehicle. Push the mirror back out when finished.
See also:
Engine Coolant Temperature
Warning Light
This light comes on briefly
while starting the vehicle.
If it does not, have the vehicle serviced by the
dealer/retailer. If the system is working normally the
indicator light goes off.
Noti ...
Canceling a Remote Start
To cancel a remote start, do any of
the following:
• Aim the RKE transmitter at the
vehicle and press and hold
until the parking lamps turn off.
• Turn on the hazard warning
flashers.
...
Towing the Vehicle
Notice: To avoid damage, the disabled vehicle should be towed with all four wheels
off the ground. Care must be taken with vehicles that have low ground clearance
and/or special equipment. Always ...