Fuses and Circuit Breakers
The wiring circuits in the vehicle are protected from short circuits by a combination of fuses and circuit breakers. This greatly reduces the chance of damage caused by electrical problems.
To check a fuse, look at the silver-colored band inside the fuse.
If the band is broken or melted, replace the fuse. Be sure to replace a bad fuse with a new one of the identical size and rating.
Fuses of the same amperage can be temporarily borrowed from another fuse location, if a fuse goes out. Replace the fuse as soon as possible.
To identify and check fuses, circuit breakers, and relays, see Engine Compartment Fuse Block, Instrument Panel Fuse Block, and Rear Compartment Fuse Block.
See also:
RKE without Remote Start Shown
(Unlock): Press to unlock the driver
door or all doors. See “Auto Door Unlock” under Vehicle Personalization .
The turn signal indicators may flash and/or the horn may sound to indicate unlo ...
Jump Starting (On-board with eAssist Only)
If the vehicle fails to crank, it may
be jump started by using the eAssist
battery to charge the 12-volt battery.
Use the following procedure to
activate the on-board jump start
using the DIC ...
Driving on Wet Roads
Rain and wet roads can reduce
vehicle traction and affect your
ability to stop and accelerate.
Always drive slower in these types
of driving conditions and avoid
driving through large puddles ...