License Plate Lamp

The license plate lamps for this vehicle are on the trunk lid.

To replace one of these bulbs:

1. Open the trunk. See Trunk for more information.

2. Push the end on either of the

2. Push the end on either of the lamp assemblies (passenger side shown) and then move the lamp assembly down to remove it from the trunk lid.

A. Bulb Socket

A. Bulb Socket
B. Bulb
C. Lamp Assembly

3. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).

4. Pull the bulb (B) straight out of the bulb socket.

5. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly.

6. Move the lamp assembly into the trunk lid, engaging the clip side first.

7. Push on the lamp side opposite the clip until the lamp assembly snaps into place.

    See also:

    Exit Lighting
    With exit lighting, the interior lamps come on when you remove the key from the ignition. If the dome override is off, these lamps stay on for a short period of time and then go out. ...

    Scheduling Service Appointments (U.S. and Canada)
    When the vehicle requires warranty service, contact your dealer and request an appointment. By scheduling a service appointment and advising the service consultant of your transportation nee ...

    Manual Locks
    From the outside, unlock the door using either the key or the RKE transmitter. From the inside, use the power door lock switches or manual lock knobs located at the top of the door panel near t ...