Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

A. Back-Up Lamp

A. Back-Up Lamp
B. Turn Signal Lamp

To replace one of these lamps:

1. Open the trunk. See Trunk.

2. Remove the fasteners and pull back the trunk trim.

3. Remove the four plastic wing nuts holding the taillamp assembly in place.

4. Pull out the taillamp assembly and disconnect the wiring harness.

5. Turn the bulb socket counterclockwise to remove it.

6. Pull the old bulb straight out of the bulb socket.

7. Reverse Steps 1 through 6 to install.

    See also:

    High/Low-Beam Headlamps (Up-Level)
    The high/low-beam headlamps on the up-level headlamp system are High Intensity Discharge (HID) and should be replaced at the dealer. ...

    Cruise Control
    With cruise control, the vehicle can maintain a speed of about 40 km/h (25 mph) or more without keeping your foot on the accelerator. Cruise control does not work at speeds below 40 km/h (25 mph). On ...

    To Use the Engine Coolant Heater
    1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. 3.6L V6 Engine The electrical cord is located on the driver side of the engine compartment, between the fender and ...