When the System Does Not Seem to Work Properly
The following messages may be displayed on the DIC:
SERVICE PARK ASSIST: If this message occurs, take the vehicle to your dealer to repair the system.
PARK ASSIST OFF: If the URPA system does not activate due to a temporary condition, this message displays on the DIC. This can occur under the following conditions:
• The driver has disabled the system.
• The ultrasonic sensors are not clean. Keep the vehicle's rear bumper free of mud, dirt, snow, ice, and slush. For cleaning instructions, see Exterior Care.
• The park assist sensors are covered by frost or ice. Frost or ice can form around and behind the sensors and may not always be seen; this can occur after washing the vehicle in cold weather. The message may not clear until the frost or ice has melted.
• An object was hanging out of the trunk during the last drive cycle.
Once the object is removed, URPA will return to normal operation.
• The bumper is damaged. Take the vehicle to your dealer to repair the system.
• Other conditions, such as vibrations from a jackhammer or the compression of air brakes on a very large truck, are affecting system performance.
See also:
Why Safety Belts Work
When you ride in or on anything, you go as fast
as it goes.
Take the simplest vehicle. Suppose it is just a
seat on wheels.
Put someone on it.
Get it up to speed. Then stop the vehicle.
...
Lower Anchor and Top Tether Anchor Locations
Rear Seat
(Top Tether Anchor): Seating positions
with top tether anchors.
(Lower Anchor): Seating positions
with two lower anchors.
To assist you in locating the lower anchors, each rear a ...
Services Specific to Canadian-Purchased Vehicles
• Fuel delivery: Reimbursement
is approximately $5 Canadian.
Diesel fuel delivery may be
restricted. Propane and other
fuels are not provided through
this service.
• Lock-Out Service: Ve ...
