Turning the System On and Off
The URPA system can be turned on and off using the park assist button located next to the shift lever.
The LED next to the park assist button lights up when the system is on and turns off when it has been disabled.
When the system is off, PARK ASSIST OFF displays on the Driver Information Center (DIC). The message disappears after a short period of time.
URPA defaults to the on setting each time the vehicle is started.
See also:
Lower Anchor and Top Tether Anchor Locations
Rear Seat
(Top Tether Anchor): Seating positions
with top tether anchors.
(Lower Anchor): Seating positions
with two lower anchors.
To assist you in locating the lower anchors, each rear a ...
Tire and Loading Information Label
Label Example
A vehicle-specific Tire and
Loading Information label is
attached to the vehicle's center
pillar (B-pillar). The Tire and
Loading Information label shows
the number of occup ...
When to Check and Change AutomaticTransmission Fluid
A good time to check your automatic transmission
fluid level is when the engine oil is changed.
Change the fluid and filter at the intervals listed in
Additional Required Services on page 482, and ...