Video Screens

The video screens are located in the back of the driver and front passenger seats.

To use the video screen:

To use the video screen:

1. Push the release button located on the seatback console.

2. Move the screen to the desired viewing position.

Push the video screen down into its locked position when it is not in use.

The screen turns off automatically.

Only the left RSE seatback console contains the infrared transmitters for the wireless headphones. They may be visible as eight illuminated LEDs.

These LEDs are not on the right video screen. Both seatback consoles contain an infrared receiver for the remote control. They are located at the top of each console.

Notice:
Avoid directly touching the video screen, as damage may occur. See “Cleaning the Video Screens” later in this section for more information.

    See also:

    Overheated Engine Protection Operating Mode
    If an overheated engine condition exists and the message ENGINE OVERHEATED STOP ENGINE is displayed, an overheat protection mode which alternates firing groups of cylinders helps prevent engine ...

    Checking Engine Oil
    It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the vehicle must be on level ground. The engine oil dipstick handle is a yellow loop. See En ...

    License Plate Lamp
    To replace one of these bulbs: Passenger Side Shown, Driver Side Similar 1. Push the release tab (A) toward the lamp assembly. 2. Pull the lamp assembly down to remove. A. Bulb Socket B. B ...