Gate Operator and Canadian Programming

If you have questions or need help programming the Universal Remote system, call 1-800-355-3515 or go to www.homelink.com.

Canadian radio-frequency laws require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for the Universal Remote system to pick up the signal during programming. Similarly, some U.S.

gate operators are manufactured to time out in the same manner.

If you live in Canada, or you are having difficulty programming a gate operator or garage door opener by using the “Programming the Universal Remote System” procedures, regardless of where you live, replace Step 2 under “Programming the Universal Remote System” with the following:

Continue to press and hold the Universal Remote system button while you press and release every two seconds (cycle) the hand-held transmitter button until the frequency signal has been successfully accepted by the Universal Remote system. The Universal Remote system indicator light will flash slowly at first and then rapidly. Proceed with Step 3 under “Programming the Universal Remote System” to complete.

    See also:

    Checking Coolant
    The vehicle must be on a level surface when checking the coolant level. The coolant level should be at or above the FULL COLD mark when the engine is cold. The coolant level should be above the ...

    Vehicle Information Menu Items
    Press MENU on the turn signal lever until Vehicle Information Menu is displayed. Use to scroll through the following menu items: • Unit • Tire Pressure • Jump Start (eAssist Only) • ...

    When Should an Airbag Inflate?
    Frontal airbags are designed to inflate in moderate to severe frontal or near-frontal crashes to help reduce the potential for severe injuries mainly to the driver’s or right front passenger†...