Extending Engine Run Time
The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can only be extended once.
When remote start is extended, the second 10 minutes will start immediately.
For example, if the vehicle has been running for five minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
A maximum of two remote starts or remote start attempts are allowed between ignition cycles.
The vehicle's ignition must be turned on and then back off before the remote start procedure can be used again.
See also:
Power Lumbar
On vehicles equipped with either a two-way or four-way
lumbar, the control is located on the outboard side of
the seats.
For a detailed operation description see Power Lumbar . ...
Without Selective Ride Control
1. Move the shift lever to the left
from D (Drive).
The transmission will enter
Manual Mode. The DIC gear
indicator will change to an M
followed by a number
representing the gear the vehicl ...
Using Universal Home Remote
Press and hold the appropriate button for at least
half of a second. The indicator light will come on
while the signal is being transmitted. ...