Battery Replacement

Replace the battery if the REPLACE BATTERY IN REMOTE KEY message displays in the DIC. See “REPLACE BATTERY IN REMOTE KEY” under Key and Lock Messages.

The battery is not rechargeable. To replace the battery:

1. Push the button on the transmitter to extend the key.

2. Remove the battery cover by prying it with a finger.

3. Remove the battery by pushing on the battery and sliding it toward the key blade.

4. Insert the new battery, positive side facing up. Push the battery down until it is held in place.

Replace with a CR2032 or equivalent battery.

5. Snap the battery cover back on to the transmitter.

    See also:

    Programming Universal HomeRemote — Rolling Code
    Rolling code garage door openers are used for garage doors produced after 1996 and are code protected. Rolling code means the coded signal is changed every time your remote control garage door ope ...

    Battery Run-Down Protection
    This feature shuts off the dome, courtesy, and vanity lamps if they are left on for more than 20 minutes when the ignition is off. This will keep the battery from running down. If the battery ru ...

    XM Radio Messages
    XL (Explicit Language Channels): These channels, or any others, can be blocked at a customer’s request, by calling 1-800-852-XMXM (9696). XM Updating: The encryption code in the receiver is b ...