Deleting a Paired Phone

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Bluetooth”. The system responds with “Bluetooth ready” followed by a tone.

3. Say “Delete”. The system asks which phone to delete followed by a tone.

4. Say the name of the phone to be deleted. If the phone name is unknown, use the “List” command for a list of all paired phones. The system responds with “Would you like to delete <phone name>? Yes or No” followed by a tone.

5. Say “Yes” to delete the phone. The system responds with “OK, deleting <phone name>”.

    See also:

    Turn Signals When Towing a Trailer
    The arrows on the instrument panel flash whenever signaling a turn or lane change. Properly hooked up, the trailer lamps also flash, telling other drivers the vehicle is turning, changing lanes, o ...

    Voice Recognition
    The voice recognition system uses commands to control the system and dial phone numbers. Noise: The system may not recognize voice commands if there is too much background noise. When to Spe ...

    Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
    A. Taillamp/Sidemarker Lamp B. Taillamp C. Stop/Turn Signal Lamp D. Back-up Lamp To replace any one of these bulbs: 1. Open the trunk. See Trunk Release . 2. Remove the taillamp assembly ...