Using the Re-dial Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say

Hands Free.” The system responds “Ready,” followed by a tone.

2. After the tone, say “Re-dial.” The system responds “Re-dial using <phone name>” and dials the last number called from the connected Bluetooth phone.

Once connected, the person called will be heard through the audio speakers.

    See also:

    Instrument Panel Storage
    There is a storage compartment located on the driver side of the instrument panel. ...

    Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
    A. Back-Up Lamp B. Turn Signal Lamp To replace one of these lamps: 1. Open the trunk. See Trunk. 2. Remove the fasteners and pull back the trunk trim. 3. Remove the four plastic wing nuts h ...

    If No Steam Is Coming From The Engine Compartment
    If an engine overheat warning is displayed but no steam can be seen or heard, the problem may not be too serious. Sometimes the engine can get a little too hot when the vehicle: • Climbs a lo ...