Using the Digit Dial Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.

2. Say “Digit Dial.” The system responds “Digit dial using <phone name>, please say the first digit to dial,” followed by a tone.

3. Say the digits to be dialed one at a time. The system repeats back the digit it heard followed by a tone.

4. Continue entering digits until the number to be dialed is complete.

After the entire number has been entered, say “Dial.” The system responds “OK, Dialing” and dials the number.

► If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.

► To hear all of the numbers recognized by the system, say “Verify” at any time.

    See also:

    Using the Digit Store Command
    The digit store command allows a phone number to be stored by entering the digits individually. 1. Press and hold for two seconds. The system responds with “Ready” followed by a tone. 2. ...

    Emergency Trunk Release Handle
    Notice: Do not use the emergency trunk release handle as a tie-down or anchor point when securing items in the trunk as it could damage the handle. The emergency trunk release handle is only i ...

    Entering the Personalization Menus
    1. Press CONFIG to access the Configuration Settings menu. 2. Turn the TUNE/MENU knob to highlight Vehicle Settings. Press the CONFIG button until Vehicle is highlighted on vehicles with a navigati ...