Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade): To
adjust balance or
fade, press the
if the radio has
this symbol, or the
knob until the speaker control
tabs display. Continue
pressing to highlight the desired tab, or press the
pushbutton positioned under the desired tab. Turn the
knob clockwise or counterclockwise
to adjust the
setting. The setting can also be adjusted by pressing
either SEEK arrow,
FWD, or
REV until the
desired levels are obtained.
The radio may be capable of adjusting balance or fade to the middle position by pressing the pushbutton positioned under the BAL or FADE tab for more than two seconds.
The radio beeps once and the level adjusts to the middle position.
The radio may also be capable of adjusting all speaker
and tone controls to the middle position by pressing
the knob for more than two seconds
until the radio
beeps once.
See also:
Pairing
A Bluetooth enabled cell phone must be paired to the
in-vehicle Bluetooth system first and then connected to
the vehicle before it can be used. See the cell phone
manufacturers user guide for Bl ...
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high
beam, push the turn signal lever away from you. To
change from high beam to low beam, pull the turn signal
lever toward you.
While the high beams ...
If a Tire Goes Flat
It is unusual for a tire to blow out while driving, especially if the tires are maintained properly. If air goes out of a tire, it is much more likely to leak out slowly. But if there ever is a blowou ...