Headlamps, Front Turn Signal, andParking Lamps

To replace a bulb, do the following:

1. Open the hood.
2. Remove the grille by grasping and pulling it forward.
3. Lift the two headlamp retaining clips.
4. Pull the headlamp assembly away from the vehicle to access the electrical connectors.
5. Remove the cover from the headlamp bulb.
6. Disconnect the wiring harness.
7. Remove the bulb socket by turning it counterclockwise. Pull the bulb from the socket.
8. Install the new bulb and turn clockwise to secure it.
9. Reinstall by reversing Steps 1 through 6.
10. Press down on the headlamp retaining clips to secure the headlamp assembly.

    See also:

    Driving On Grades
    Reduce speed and shift to a lower gear before starting down a long or steep downgrade. If the transmission is not shifted down, the brakes might have to be used so much that they would get hot and ...

    Brake Fluid
    The brake master cylinder and, on manual transmission vehicles, the clutch hydraulic system use the same reservoir. See Engine Compartment Overview  for the location of the reservoir. The reser ...

    Universal Remote System
    See Radio Frequency Statement for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...