Stopping and Resuming Playback
To stop playing a disc, press and release the stop button on the DVD player faceplate or the remote control.
To resume playback, press the play/pause button on the DVD player faceplate or the remote control. The movie should resume play from where it was last stopped, if the disc has not been ejected and the stop button has not been pressed twice. If the disc has been ejected or if the stop button has been pressed twice, the disc will resume play at the beginning.
See also:
Removing the Flat Tire andInstalling the Spare Tire
1. If your vehicle has a wheel cap that covers
the wheel nuts, position the chisel end of the
wheel wrench in the notch and pry it off.
2. Using the wheel
wrench, loosen all
the wheel nuts.
...
Steering Tips
It is important to take curves at a reasonable speed.
Traction in a curve depends on the condition of the tires and the road surface, the angle at which the curve is banked, and vehicle speed.
While ...
Compass Calibration Procedure
1. Before calibrating the compass, check that the
compass zone is set to the variance zone in
which the vehicle is located. See “Compass
Variance (Zone) Procedure” earlier in this section.
...