Setting Preset PTYs (RDS Only)
These buttons have factory PTY presets. Up to 12 PTYs (six FM1 and six FM2), can be programmed on the six numbered pushbuttons, by performing the following steps:
1. Press BAND to select FM1 or FM2.
2. Press the TYPE button to activate program
type select mode. TYPE and the last selected
PTY displays.
3. Turn the TYPE knob or press and release the
TYPE button to select a PTY.
4. Press and hold one of the six numbered
pushbuttons until a beep sounds. When
that numbered pushbutton is pressed (while in
program type mode), the PTY that was set,
returns.
5. Repeat the steps for each pushbutton.
See also:
Power Windows
The power window switches located on the driver door control all four windows. The passenger doors have a window switch that controls that window. Push the switch down to open the window. Pull the f ...
Audio Source
VOL/ (Volume/Power):
1. Press to turn the radio on or off.
2. Turn to increase or decrease the
volume of the active source
(i.e., current audio source, active
navigation voice guidance,
or ...
Doing Your Own Service Work
WARNING
It can be dangerous to work on your vehicle if you do not have the proper knowledge,
service manual, tools, or parts. Always follow owner manual procedures and consult
the service manua ...